Hi, I'm trying to emboss pictures made in Qiktac in Duxburry from a Versapoint. I have been trying to get the pictures to a different alignment, but they seem to stay on the left- hand side. And in some the bottoms are chopped off and continued on the next page. On the screen they look fine. When I just emboss right from Qiktac it goes fine. Any ideas as to what I am doing wrong? Thanks for any help. Regards, Lisa Lisa Yayla Huseby Kompetansesenter Oslo Norway lisa.yayla@xxxxxxxxxx * * * * This message is via list duxuser at freelists.org. * To unsubscribe, send a blank message with * unsubscribe * as the subject to <duxuser-request@xxxxxxxxxxxxx>. You may also * subscribe, unsubscribe, and set vacation mode and other subscription * options by visiting //www.freelists.org. The list archive * is also located there. * Duxbury Systems' web site is http://www.duxburysystems.com * * *