[duxhelp] Re: Embosser Setup edit box
- From: "Peter Sullivan" <peter@xxxxxxxxxx>
- To: <duxhelp@xxxxxxxxxxxxx>
- Date: Mon, 7 Jun 2004 10:25:48 -0400
Ian,
Thanks. This in fact is already fixed for beta 4.
- Peter
-----Original Message-----
From: duxhelp-bounce@xxxxxxxxxxxxx [mailto:duxhelp-bounce@xxxxxxxxxxxxx] On
Behalf Of Ian Robinson
Sent: Monday, June 07, 2004 5:48 AM
To: List DBTBeta
Subject: [duxhelp] Embosser Setup edit box
Hi,
Using Beta 3, Build Date: 24 May 2004.
1. Embosser Setup, Document or Global, it doesn't matter.
2. Press the New button.
3. Enter a setup name.
4. Choose embosser model.
5. tab to the available ports combo box; JAWS announces that "LPT1" is
selected.
6. tab once, there is an edit box which I suspect should not be available.
7. Shift tab back to the ports combo box.
8. Press cursor down once, then cursor up once, so that LPT1 is still
selected.
9. Tab once and the edit box has gone.
If in step 4 above, no embosser is selected, that is to say the setting is
left as "Generic", the extra edit box does not appear.
Cheers.
Ian
* * *
* This message is via list duxhelp at freelists.org.
* To unsubscribe, send a blank message with
* unsubscribe
* as the subject to <duxhelp-request@xxxxxxxxxxxxx>. You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting //www.freelists.org. The list archive
* is also located there.
* Duxbury Systems' web site is http://www.duxburysystems.com
* * *
* * *
* This message is via list duxhelp at freelists.org.
* To unsubscribe, send a blank message with
* unsubscribe
* as the subject to <duxhelp-request@xxxxxxxxxxxxx>. You may also
* subscribe, unsubscribe, and set vacation mode and other subscription
* options by visiting //www.freelists.org. The list archive
* is also located there.
* Duxbury Systems' web site is http://www.duxburysystems.com
* * *
Other related posts:
