Yes! to Mike's observations! -Andy -----Original Message----- From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx]On Behalf Of Mike Christer Sent: Wednesday, August 29, 2012 1:33 PM To: ddots-l@xxxxxxxxxxxxx Subject: [ddots-l] Re: recording acoustic guitars The trick is to use both, then mix & match... Remember, you might find a great mike set-up which sounds amazing, but when you play back the track it might not sit properly, or sound way too thin! The key is experimentation! Two positions I've always found pretty effective are the following: (this is assuming you're miking up a right-handed player.) 1). Place a condenser mike, pointing in at a slight angle towards the soundhole, about an inch and a half/two inches, above the 12th fret. This'll give you a balance twixt pick attack and what's coming out of the guitar. Again, experiment with position/distance. 2). Place another condenser, pointing in, at an angle towards the guitar, above the player's left shoulder. This might sound stupid, but if it sounds good to the guy playing, this should, hopefully, capture a bit of what he's hearing. Again, you must experiment! This position will definitely depend on the quality of the mike. I could go in to myriad other concepts, like miking up behind/in front of the body etc. etc... but, hey... l8r ----- Original Message ----- From: Manny To: ddots-l@xxxxxxxxxxxxx Sent: Wednesday, August 29, 2012 6:05 PM Subject: [ddots-l] recording acoustic guitars Hi all, Many over here with a quick question. When recording an acoustic guitar, is it better to use a microphone or the pickup on it. Does it make a difference when recording an acoustic strum compared to lead rifts. Thanks, manny