Mat wrote: Phil is there anyone who could perhaps help you organise the spot sets in to those appropriate for CT users and those for J Sonar users? Phil replied: What, and start a logistical nightmare for me maintaining the site? that's not going to happen. All HSC sets work both in CT and JSonar. No point wasting my or, someone else's time doing that. That's the point. You can use any HSC set ether with CT or, JSonar. I truly believe in freedom of choice and I am not an American, grin. Mat wrote: I was looking at the full list today, and I kept saying to myself hang on, CT already supports that I'm sure! But does CT support the things HSC supports, as well as HSC? Phil replied: that's an interesting question. I do have CT installed here however, I find myself using my HSC sets more than the built-in CT support. That's possibly cause if I use HSC then, I don't have to use any of those CT F4 dialogs. Also, if you have Sonar 7 then, you will be able to use Boost11, the new Linear Compressor and even if you are still using Sonar 6 then, you will have some HSC support in the Roland Groove Synthe which, CT doesn't support. I find the HSC sets, a little less verbose than CT. Mat wrote: Would installing those spot sets screw with CT at all? Phil replied: no. All HSC sets have been thoroughly tested in JSonar and CT and there are no keyboard conflicts at all. Mat wrote: I understand CT works with HSC, but I imagine that's only for areas where CT does not actively offer support correct? Phil replied: not at all. You can happily use HSC in dialogs where there is CT support. I have worked hard with David Pinto on this to make sure that HSC works flawlessly with CT. Regards, Phil Muir P J Muir Productions Music And Audio Production URL: www.philmuir.com/ Band website: www.steelstringmusic.co.uk/ Band my Space Site: www.myspace.com/steelstringmusic