I'll put it to you as i put it to my sighted peers. Listen to how the music sounds don't try and see how it sounds, for you listen to the music not to jaws. Haha feel your pain have the same problem and sometimes you have to set by value can't always set by ear. I know some sighted people who can't mix to save their lives if i turn off the digital mixers screen coz they can't see the wave. Good luck man -original message- Subject: [ddots-l] Determining Plug-in Parameter Settings? From: Chris Smart <chris_s@xxxxxxxxxxxx> Date: 22/11/2010 21:01 HI folks. I have quite a number of plug-ins that display the following behavior. When in the track inspector and changing parameter values with the various value change keys, Jaws seems to stay one value behind. For example, if I'm adjusting a control towards its maximum, let's call it 10, no matter what, I can get it one step below 10, according to Jaws. Let's say I go up a number of times, until the value is reported as 9.8 and seems to go no further. then, I go down one key press, and Jaws reports 10, the maximum I was trying to reach by going up. So, how do I reliably interpret these results? Go back and forth on a parameter and ssume that the second to last value reported is indeed where the control is set? Chris PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribe For other list commands such as vacation mode, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=faq or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq PLEASE READ THIS FOOTER AT LEAST ONCE! To leave the list, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject=unsubscribe If this link doesn't work then send a message to: ddots-l-request@xxxxxxxxxxxxx and in the Subject line type unsubscribe For other list commands such as vacation mode, click on the immediately following link: ddots-l-request@xxxxxxxxxxxxx?subject�q or send a message, to ddots-l-request@xxxxxxxxxxxxx and in the Subject line type faq