On 10 Dec 2007 Tim Powys-Lybbe <tim@xxxxxxxxx> wrote: > In message of 10 Dec, Dr Peter Young <pnyoung@xxxxxxxxxxxx> wrote: >> I'm trying to print a two-page letter making fairly extensive use of >> mailmerge, and I want to print this on two sides of the same sheet; I >> don't have a duplex printer. >> >> As far as I can see, there is no way of printing only a side at a time >> when using mailmerge. In particular, setting "pause" in Print Setup >> appears to have no effect. Is this really so, or am I doing something >> wrong somewhere? > I would try putting but one piece of paper in the paper feed tray, > myself. After doing the first side the printer should then stop and > should restart OK when you turn it over and feed it in again. Thanks for the suggestion, but I'd be a bit reluctant to try that. With my previous inkjet any attempt to print on non-existent paper resulted in a foul-up of the whole printing system, needing a hard reset to get out of. I don't know whether that would happen with my current Xerox Phaser, but I don't think I'll try. In the meanwhile, and in case there isn't an "official" solution, I've got a rather circuitous work-round using PrintPDF and then printing "Current page only" from RiScript. With best wishes, Peter. -- Peter \ / zfc Er \ Prestbury, Cheltenham, Glos. GL52 Anne \/ __ __ \ England. and / / \ | | |\ | / _ \ http://pnyoung.orpheusweb.co.uk family / \__/ \_/ | \| \__/ \______________ pnyoung@xxxxxxxxxxxxx