Hi Orin,
There’s a button you need to press on the autopilot panel to actually set
COM1, I think. It was labeled “COM1,” if I recall. I don’t know about the
console command.
Best,
Zack.
On Jul 13, 2017, at 7:40 PM, Joshua Tubbs <orin8722@xxxxxxxxx> wrote:
Hi all,
Would anyone who uses FSX Pilot to set Com1 have an idea why, despite
going to the com1 field and inputting a value in it and pressing
enter, it doesn't set?
I'm not sure if there's a command to set it in the console. I know to
set the transponder it's "set transponder <squalk>, but there doesn't
appear to be a command for that to set Com1. Furthermore, I can type
"set altitude <feet> and it'll set the altitude. However, when I shift
tab from the console, I see my altitude number there, but when I say
input another value in and hit enter, it doesn't set. Is sapi supposed
to say the new value when inputted? I know it does when I set it in
the console.
The com1 command I found in the manual was rather confusing, it was
something like set com [com1] <frequency>. However, I think that's
specifically for the explicit use in TXT flightplan files.
Any help on this would be greatly appreciated.
Blind and Visually impaired Pilots mailinglist
//www.freelists.org/list/bvipilots
To post a message to the list, send a message to
bvipilots@xxxxxxxxxxxxx
To unsubscribe, send a message to
bvipilots-request@xxxxxxxxxxxxx and put the word unsubscribe in the subject
of your message.
For other options such as digest, send a message to
bvipilots-request@xxxxxxxxxxxxx and put the word help in the subject of your
message.
