I can do it. I'm not super burdened with classes On Thu, Oct 3, 2013 at 7:18 PM, Ben Ha <benha@xxxxxx> wrote: > I can help out with this but I don't have enough time to fully commit to > it. > > Ben Ha > > > On Thursday, October 3, 2013, Carolina Munoz wrote: > >> I'd be down to work on this too. >> >> >> On Thu, Oct 3, 2013 at 3:34 PM, Gherman Howell <gshowell@xxxxxx> wrote: >> >> I'm up for being on a team that works on it, but I am not confident in my >> knowledge or experience to take it on my own, not to mention not having the >> time to finish it by november. I think that the project would be much more >> successful if a team of around 2-3 people worked on it anyway. >> >> >> On Thu, Oct 3, 2013 at 1:14 PM, Michael Pettit <mtpettit@xxxxxx> wrote: >> >> Ditto to what Cory said, I have way too much other work to get this >> project done in a reasonable amount of time, but I can help out with the >> CAD or in another way if needed. >> >> >> >> On Thu, Oct 3, 2013 at 11:09 AM, Cory Absi <cory.absi@xxxxxxxxx> wrote: >> >> I probably don't have time to do this but if a freshman takes this on I >> can help them out with the CAD and teach them methods in Solidworks for >> doing it. There is CAD software installed on all the computers in the CAD >> lab on the 3rd floor in the ME building for those of you who don't know. >> -Cory >> >> >> On Thu, Oct 3, 2013 at 9:20 AM, D. Armor Harris <davidh@xxxxxx> wrote: >> >> I think the only complicated part is the shaft that connects the servo to >> the valve, but there is an off the shelf shaft that Mehmet knows a lot >> about. >> >> Drew can give you the model info of the servos (and we have one in the >> wind tunnel lab), and Chris Hayes was the one who did the old units. >> >> Lance and Osi, you guys should tag up with the above people and it should >> be everything you need. >> >> On Thursday, October 3, 2013, Lance Nakano wrote: >> >> I might be interested in making these, are the designs fairly simple or >> are there some complex portions? >> >> Lance Nakano >> >> >> On Thu, Oct 3, 2013 at 1:39 AM, D. Armor Harris <davidh@xxxxxx> wrote: >> >> Hey guys, >> >> We need someone to design and manufacture two mounts to hold the new >> servo-actuated valves on the N2O and N2 ground lines. We're getting rid of >> the old planetary gear motor/arduino system that was the source of all evil >> last year and replacing it with a nice slick servo system. >> >> We have the valves and we have the servos, we just need someone to make >> the mounts that keep the servo attached to the valve to actuate it. Email >> me back if interested. >> >> It's a good opportunity to get involved in some design and manufacture >> work if you are new, as you can probably do it in Tinker and it's not a >> "need to get it right the first time" thing. We do need them by the >> beginning of November. >> >> >> -- >> David Armor Harris >> Boston University Rocket Propulsion Group >> davidh@xxxxxx >> >> >> >> >> -- >> Sent from my phone >> >> >>