In the station properties within RAV 8 make sure: Recordings tab shows: record by downloading streams - radio button And Type: combo box has: Stream capture Choose OK. --- pamdrake <pamdrake@xxxxxxxxxxxxx> wrote: > Petro > > Well, I just tried tuning the station again. I did as you > suggested, but > after pressing the applications key plus t there was > Once again silence. I did select windows media player for > conversion after > recording, but as I heard no sound I doubt there would have > been a recording > if I had attempted one. > > The stream shown by the url finder is: > http://wmc1.liquidviewer.net/KAAM.smi > > Now I just tried clicking on the link which appeared in my own > message and > got a message saying that Windows Internet Explorer could not > play the file > because it was unable to open the url. The url could not be > found. > > I wish I could take a screen shot of this site when I try > loggin in. > Unfortunately my keyboard is non-standard and the key which I > believe should > be the print screen key causes my computer to shut down! > Wouldn't I have to > send the screen shot to a sighted person anyway to have it > read? > > I hope someone here can figure out what the problem may be. > > The actual site to which I go to play the live stream is > www.kaamradio.com/ > > Thanks again. > > Pam > > -----Original Message----- > From: blindreplay-bounce@xxxxxxxxxxxxx > [mailto:blindreplay-bounce@xxxxxxxxxxxxx] On Behalf Of > petrakigianos-giasou@xxxxxxxxx > Sent: Tuesday, March 06, 2007 3:03 PM > To: blindreplay@xxxxxxxxxxxxx > Subject: [blindreplay] Re: capture stream or not > > Pam > My guess is you did something wrong. Try this just to be sure. > Go to the listview where your stations are listed in RAV 8. > Arrow down to the station and stop there. Now press your > applications key. > Press "T" for Tune to station. See if the stream works. > > If the stream works you will hear the audio through your > speakers. This is a > small test. > > You will be in a Tuner dialog box with various buttons. This > is for WMP > streams. Use your tab key to navigate to these buttons: > Stop, Volume slider and so on. You use space bar to activate > one of these > buttons in the Tuner dialog box that pops up. I have not > touched the mute > button. To switch back and forth between RAV 8 and Tuner > dialog box use your > ALT+TAB keyboard command. To close the Tuner dialog box use > ALT+F4 command > and you will be back on RAV 8 program. Just letting you know > all this. > > If you get no audio after doing applications key and "T" then > something is > wrong for sure. Many factors: bad URL link, check properties > area to see if > you have told it the right media player choice like Windows > Media player and > so on. > > Can you send me the actual URL address you were trying to > record? > > Not sure if you know how so I am posting instructions here: > > Highlight station in listview box. > Press Applications key. > Choose "P" for Properties for Properties dialog xcreen. > Go to Basic tab page. > Tab a few times in the Basic page until you hear URL: edit > box. > Copy the URL address yu have in there. > Press escape key to leave without affecting your settings in > properties > screen. > > Post this URL to this list for me and others to test. > > I tested WMKV today and it is working as you say. No issues. > You are correct > with yur analysis. > > I hope I didn't forget anything. > > Petro > > -- > To unsubscribe: e-mail blindreplay-request@xxxxxxxxxxxxx with > unsubscribe in subject > To contact list owner: e-mail blindreplay-admins@xxxxxxxxxxxxx > -- To unsubscribe: e-mail blindreplay-request@xxxxxxxxxxxxx with unsubscribe in subject To contact list owner: e-mail blindreplay-admins@xxxxxxxxxxxxx