HI Steve. Yep, when I got the latest transfer tool, I formatted the flash= card in bc and then re sent all my files. Brian. *********** REPLY SEPARATOR *********** On 12/21/2004 at 8:55 AM Steve Gomas wrote: >Brian, > >Is the file you're having problems with transferred with the latest >transfer tool? > >Steve > >At 08:11 AM 12/21/2004, you wrote: >>Hi all. Ok, got the latest transfer software can't look at the= version=3D >> number at the moment but it ends in 07 and firmware 01.02.i5 >> >>I still have problems navigating in text files. while the move by=3D >> sentence, paragraph and page seems to work a little better, the= percentage=3D >> indicator is screwed up and reports anything from 0 percent to 271= percent=3D >> at various points in the file. also the movement with shift and 4 and= 6=3D >> doesn't work at all. it often reports beginning of file with shift 6= and=3D >> doesn't actually move any place and it is totally inconsistant. >> >>anyone else experiencing these problems? >> >>Perhaps my text files don't have well defined page ascii 12 characters= but=3D >> the percentage indicator should still work. >>I will play around a bit more. perhaps I will have different results= using=3D >> k1000 to transfer the files rather than the transfer tool directly. >> >>Brian. > >Springer Design, Inc. >925-242-0310 >925-242-0357 FAX >This message and any attached files contain proprietary and confidential >information and are intended only for the addressee.