[audacity4blind] Re: Poor Recording Quality

  • From: "" <dmarc-noreply@xxxxxxxxxxxxx> (Redacted sender "sgsmg49" for DMARC)
  • To: <audacity4blind@xxxxxxxxxxxxx>
  • Date: Fri, 25 Sep 2020 10:34:00 -0400

Hello Robert,

I think that did it.  My test recording sounded fantastic.  I'll give a follow 
up after  I do some complete recordings.  Thanks so much.  This list is the 
absolute best.

Steve

-----Original Message-----
From: audacity4blind-bounce@xxxxxxxxxxxxx 
[mailto:audacity4blind-bounce@xxxxxxxxxxxxx] On Behalf Of Robert Hänggi
Sent: Thursday, September 24, 2020 10:42 PM
To: audacity4blind@xxxxxxxxxxxxx
Subject: [audacity4blind] Re: Poor Recording Quality

Yes, that's right, Wasapi loopback has a fixed gain hence the term bit perfect.
You would set the gain within Amazon Music via the volume slider. I've
never used it, is it a web application or a desktop app?

The 32-bit resolution is only internal.
Let's say that the audio is 16 bit and your highest peak is (in binary)
1110011010100111 = 59047/65536 = 0.9009857177734375

you amplify by -12 dB while staying in 16 bit:
0011100110101001 = 14761/65536 = 0.2252349853515625
If you would amplify by 12 dB again, the last two bits would be lost.
Not much of a deal, max 3/65536 get lost.
However, the 32-bit representation preserves the two bits (within
limits) and you can thus make thousands of edits without noticeable
effect.
The bit depth I'm talking about is on the recording (e.g. mic) and
playback (e.g. loopback) side.

Press Windows+R and enter or paste:
mmsys.cpl
(two m at the start) -> OK
You should now be on the playback tab.
select your output device and tab to the properties button

A device dialog pops up.
The tabs you're most likely interested in are the third
(enhancements), the forth (format) and possibly the fifth (spacial
effects).
Turn everything off on #3 and 5.
Set #4 (format) to stereo, 44100, 24 bit.

Nothing to change in Audacity.
Cheers
Robert

On 25/09/2020, Redacted sender sgsmg49 for DMARC
<dmarc-noreply@xxxxxxxxxxxxx> wrote:

Hi Robert and Andrew,

I'm not sure if I'm going forward or backwards here. My sample rate is 44.1
and bit depth 32. I've had no other programs running other than the browser
and Jaws.  I'm not sure what you mean by enhancements but I haven't enabled
anything special in the program.  I switched over to Wasapi.  For recording
device I really saw no real choice other than loop back.  When I went to set
my recording level there was no slide tool for recording level, only
playback and it had no effect on the recording level while monitoring.  The
level seemed stuck on -2db. Does any of this sound right?  I made a test
recording with these settings and ran it through Amplify and exported it as
mp3.  It seemed to sound better.  I need to give it a fresh listen in the
morning  with a clear brain. Thanks so much for your help and I hope I'm on
the right track.

Steve

-----Original Message-----
From: audacity4blind-bounce@xxxxxxxxxxxxx
[mailto:audacity4blind-bounce@xxxxxxxxxxxxx] On Behalf Of Robert Hänggi
Sent: Thursday, September 24, 2020 1:21 AM
To: audacity4blind@xxxxxxxxxxxxx
Subject: [audacity4blind] Re: Poor Recording Quality

It would be desirable to use Wasapi if possible. Firstly, it makes a
bit-perfect copy, secondly it can record in 24 bit and thirdly, it
doesn't go through the analogue round trip. My stereo mix (=What you
hear) was awful when the audio interface was providing it.
Of course, there are differences from manufacturer to manufacturer.
Are all enhancements turned off?
If the sound is muffled, then the bit depth is hardly the culparate
since that has more influence on dynamic range and a higher noise
floor. It does rather suggest that the sample rate isn't up to the
task. Check all possible settings for it, Audacity, the hardware tab
etc.
Also, make sure that you actually record the system sound and not the
playback through the internal microphone.
Robert

On 24/09/2020, Andrew Downie <access_tech@xxxxxxxxxxxxxx> wrote:
Hi Steve

Re the bit depth, if you go into Preferences with control+p and press q
you
will be on the quality settings.  There you can adjust both sample rate
and
bit depth.  I would be surprised though if you are set to anything less
than
16 bit.

Yes, there could well be a difference between the Behringer and stereo
mix.
I would use stereo mix as a last resort.  Are you able to record from
Amazon
with the Behringer - it would need to be set as the default card.  You
would
have to kill the JAWS speech once recording started if you cannot route
it
somewhere else.

Can you connect a set of headphones to listen to the recording coming off
Audacity?  That will give you a better idea as to whether the problem is
occurring during the recording, which I suspect it is.





Andrew





From: audacity4blind-bounce@xxxxxxxxxxxxx
<audacity4blind-bounce@xxxxxxxxxxxxx> On Behalf Of Redacted sender
"sgsmg49"
for DMARC
Sent: Tuesday, 22 September 2020 11:39 PM
To: audacity4blind@xxxxxxxxxxxxx
Subject: [audacity4blind] Re: Poor Recording Quality



Hello Andrew,



Thanks for responding.  I'll try to answer all your questions.  It's hard
to
tell the quality of the source as well as the audacity playback since
it's
coming through the little laptop speakers.  My default sample rate is
44.1
and I'm not sure where to find the bit rate setting to check that.  My
records and cassettes were recorded through a small Baringer USB mix.
For
these current recordings I've used this mix  as a separate card to
channel
Jaws out of the recording. Would there be a difference using Wasapi
instead
of Stereo Mix?   I'm open to any suggestions.  Thanks again.



Steve



From: audacity4blind-bounce@xxxxxxxxxxxxx
<mailto:audacity4blind-bounce@xxxxxxxxxxxxx>
[mailto:audacity4blind-bounce@xxxxxxxxxxxxx] On Behalf Of Andrew Downie
Sent: Tuesday, September 22, 2020 3:47 AM
To: audacity4blind@xxxxxxxxxxxxx <mailto:audacity4blind@xxxxxxxxxxxxx>
Subject: [audacity4blind] Re: Poor Recording Quality



Hey Steve, disappointing.  Some questions follow.

What does the recording sound like in Audacity before you export?  If it
sounds good at that point, it seems that something is going wrong in the
export process.  If it is muffled in Audacity the problem would be with
the
original recording.

You mentioned that you have set recording quality to high.  What is the
default sample rate and default bit depth?  I suggest a minimum of
44.1khz
and 16 bit respectively as a minimum.  Given that your previous
recordings
were ok, I suspect you have set those values appropriately.

Does the sound seem ok as you are recording?  I have had no experience
with
Amazon Music and do not know what quality is like.  Again, I imagine you
would have noticed if that was an issue.

Did you record your cassettes and records through stereo mix or via a
cable?





Andrew





From: audacity4blind-bounce@xxxxxxxxxxxxx
<mailto:audacity4blind-bounce@xxxxxxxxxxxxx>
<audacity4blind-bounce@xxxxxxxxxxxxx
<mailto:audacity4blind-bounce@xxxxxxxxxxxxx> > On Behalf Of Redacted
sender
"sgsmg49" for DMARC
Sent: Tuesday, 22 September 2020 11:09 AM
To: audacity4blind@xxxxxxxxxxxxx <mailto:audacity4blind@xxxxxxxxxxxxx>
Subject: [audacity4blind] Poor Recording Quality



Hello,



I've been doing some recordings from Amazon Music and am not happy with
the
quality of the sound of my recordings.  I've recorded many cassettes and
records with great results.  I'm using a Dell laptop with Real tech card
and
using Stereo Mix.  I've set the recording level at -6 db. I have
recording
quality set to high in preferences. I run amplify  before making labels.
I
export to mp3 using the insane presets.  The end result just doesn't
sound
very good, kind of muffled, just low quality sound.  Any suggestions?
Any
help appreciated.

Steve



The audacity4blind web site is at
//www.freelists.org/webpage/audacity4blind

Subscribe and unsubscribe information, message archives,
Audacity keyboard commands, and more...

To unsubscribe from audacity4blind, send an email to
audacity4blind-request@xxxxxxxxxxxxx
with subject line
unsubscribe



The audacity4blind web site is at
//www.freelists.org/webpage/audacity4blind

Subscribe and unsubscribe information, message archives,
Audacity keyboard commands, and more...

To unsubscribe from audacity4blind, send an email to
audacity4blind-request@xxxxxxxxxxxxx
with subject line
unsubscribe



The audacity4blind web site is at
//www.freelists.org/webpage/audacity4blind

Subscribe and unsubscribe information, message archives,
Audacity keyboard commands, and more...

To unsubscribe from audacity4blind, send an email to
audacity4blind-request@xxxxxxxxxxxxx
with subject line
unsubscribe



The audacity4blind web site is at
//www.freelists.org/webpage/audacity4blind

Subscribe and unsubscribe information, message archives,
Audacity keyboard commands, and more...

To unsubscribe from audacity4blind, send an email to
audacity4blind-request@xxxxxxxxxxxxx
with subject line
unsubscribe

Other related posts: