Attempted to flash my new atreus kit using the standard
atreus-dvorak.hex. Seems like avrdude works properly, but then the
atreus is still QWERTY layout. Unplugging and plugging in again does
not change it to Dvorak. What am I missing here?
ejr@ejr-ThinkPad-X220-Tablet:~$ sudo avrdude -p atmega32u4 -c avr109
-U flash:w:atreus-dvorak.hex -P /dev/ttyACM0
Connecting to programmer: .
Found programmer: Id = "CATERIN"; type = S
Software Version = 1.0; No Hardware Version given.
Programmer supports auto addr increment.
Programmer supports buffered memory access with buffersize=128 bytes.
Programmer supports the following devices:
Device code: 0x44
avrdude: AVR device initialized and ready to accept instructions
Reading | ################################################## | 100% 0.00s
avrdude: Device signature = 0x1e9587 (probably m32u4)
avrdude: NOTE: "flash" memory has been specified, an erase cycle will
be performed
To disable this feature, specify the -D option.
avrdude: erasing chip
avrdude: reading input file "atreus-dvorak.hex"
avrdude: input file atreus-dvorak.hex auto detected as Intel Hex
avrdude: writing flash (15216 bytes):
Writing | ################################################## | 100% 1.19s
avrdude: 15216 bytes of flash written
avrdude: verifying flash memory against atreus-dvorak.hex:
avrdude: load data flash data from input file atreus-dvorak.hex:
avrdude: input file atreus-dvorak.hex auto detected as Intel Hex
avrdude: input file atreus-dvorak.hex contains 15216 bytes
avrdude: reading on-chip flash data:
Reading | ################################################## | 100% 0.16s
avrdude: verifying ...
avrdude: 15216 bytes of flash verified
avrdude: safemode: Fuses OK (E:C8, H:D0, L:FF)
avrdude done. Thank you.
ejr@ejr-ThinkPad-X220-Tablet:~$ qwertyuiop asdfghjkl;zxcvbnm,./
