[argyllcms] Re: printer calibration for guttenprint driver OT?
- From: adam k <aak1946@xxxxxxxxx>
- To: "argyllcms@xxxxxxxxxxxxx" <argyllcms@xxxxxxxxxxxxx>
- Date: Sat, 3 Sep 2011 09:24:37 -0400
How can I proceed using Colormunki?
Thank you.
A Kielcz
On Sep 3, 2011, at 9:16 AM, edmund ronald <edmundronald@xxxxxxxxx> wrote:
> you can make your own profile. i recommend using "density" only
>
> On 9/3/11, adam k <aak1946@xxxxxxxxx> wrote:
>> Hello,
>> I would like to calibrate my R1800 for use with Printphoto program. I would
>> like to use Colormunki to calibrate printer, but I'm not sure how to print
>> Colormunki
>> targets using guttenprint driver. Is it possible? If yes, how?
>> I understand that profiles created using Epson drivers are not good in
>> guttenprint. Right?
>> Thank you!
>>
>> --
>> Adam Kielcz
>>
>> Note: If you forward this email, please delete the forwarding
>> history, which includes my email address and any others you see in
>> this email. It is a courtesy to me and others who may not wish to have
>> their email addresses sent all over the world. Erasing the history
>> also helps prevent Spammers from gathering addresses and prevents
>> viruses from being sent to your friends and mine.
>> ---------------------------------------------------------------------------------------
>> No trees were harmed in the posting of this message . . . however an
>> extraordinarily large number of electrons were horribly
>> inconvenienced.
>>
>
Other related posts:
