[argyllcms] Re: patch 2561 of 3000: sample read failed

  • From: Niccolò Belli <darkbasic4@xxxxxxxxx>
  • To: argyllcms@xxxxxxxxxxxxx
  • Date: Fri, 26 Nov 2010 00:58:32 +0100

I don't think this is the problem, because I already calibrated with
3000 patches lots of times without any problem. I got 'sample read
failed' few times, but even with 200-600 patches.
Also, my monitor has a very low drift because it has luminance drift
compensation.
After the sample read error I restarted dispread and I successfully
created the profile with very good results:
Profile check complete, peak err = 0.226112, avg err = 0.027651, RMS =
0.035537


Il 25/11/2010 23:10, Graeme Gill ha scritto:
> Sounds excessive. Displays are generally better behaved than printers, so
> if you are using anything over 1000 test patches you need to determine if
> it is adding anything, or simply adding problems due to instrument and/or
> display drift.

Profiling only takes 2 hours, but it's just the last step:
- 1,5 hours to let the monitor warm up
- 1 hour for hardware calibration
- 2 hours for profiling

If I don't need the PC it's not a problem, but seeing an error when it
reached 90% is always frustrating :(

Darkbasic

Other related posts: