[argyllcms] Re: colprof has different behavior run by dispcalGUI and in the command line
- From: Florian Höch <lists+argyllcms@xxxxxxxxx>
- To: argyllcms@xxxxxxxxxxxxx
- Date: Fri, 01 Feb 2013 18:42:37 +0100
Hello Hugo,
Am 01.02.2013 16:52, schrieb Hugo Meinedo:
> Dear Florian,
>
> Thank you very much for the explanation.
> Yes I had the "black point compensation" box ticked in dispcalGUI.
> To understand what was going on I had to look at the source code.
> When the user selects "black point compensation" dispcalGUI applies it to the
> values and creates a temporary .ti3 which is then used by colprof to generate
> the profile.
> Then, after the run, this temporary .ti3 is deleted and only the original one
> is stored.
> It would be nice if the temporary .ti3, with the black point compensation
> applied, could also be stored along with the original one.
I can do that. The file could be stored with "bpc.ti3" extension to
distinguish it from the unaltered measurement data.
--
Florian Höch
Other related posts:
