[argyllcms] Re: [argyllcms]

  • From: Florian Höch <lists+argyllcms@xxxxxxxxx>
  • To: argyllcms@xxxxxxxxxxxxx
  • Date: Sun, 20 Jun 2010 22:16:26 +0200


have you followed the driver signing/test mode/F8 boot procedure that is necessary for the Argyll Win7 64 drivers like outlined on this list a while ago? I assume so, as you were able to install the driver. Just checking.

Am 20.06.2010 21:24, schrieb nino@xxxxxxxx:
Yes, Roger, I double checked: DTP94 is linked to Argyll LibUSB driver.
When I try to run dispcal for example I get "Error - icoms -
set_ser_port: port number out of range!"


*From:* argyllcms-bounce@xxxxxxxxxxxxx
[mailto:argyllcms-bounce@xxxxxxxxxxxxx] *On Behalf Of *Roger Breton
*Sent:* Sunday, June 20, 2010 10:18 PM
*To:* argyllcms@xxxxxxxxxxxxx
*Subject:* [argyllcms] Re: [argyllcms]

Whew? Windows 7 64 bit giving you USB issues? You’re sure you have the
instruments linked to the Argyll LibUSB driver, and not X-Rite’s? Did
you look into Computer – Manage – Devices?


*From:* argyllcms-bounce@xxxxxxxxxxxxx
[mailto:argyllcms-bounce@xxxxxxxxxxxxx] *On Behalf Of *nino@xxxxxxxx
*Sent:* 20 juin 2010 09:23
*To:* argyllcms@xxxxxxxxxxxxx
*Subject:* [argyllcms]


I am trying to run Argyll, but the communication port of my device, a
DTP94b, is not found when I try dispcal (Under -c listno I get ** No
ports found **). I uninstalled the device completely before installing
it from scratch with the Argyll driver for win7 64bit. Didn't help.

thanks in advance for any help


Florian Höch

Other related posts: