Le lundi 19 août 2013 à 11:56 +1000, Graeme Gill a écrit : > man-d wrote: > > > I'm not sure if I'm doing things right as I do not get any result. > > Hi, > the general instructions for using strip instruments are > here <http://www.argyllcms.com/doc/instruments.html#strip>. > Thank you. Had to scroll more to get those instructions. Sorry. Helps a lot. > You can test the bell using "dispwin -r". Yes I can hear the bell. It is not the hardware bell. > > At the end of each strip you will be prompted by the bell and the > terminal text. If a strip read is successful, then simply proceed > to the next strip being prompted. You use "d" at the very end, > when the whole chart is done. > > Graeme Gill. > Ok! I restarted the process. After instrument calibration I place it in front of the patch in the with space and press the instrument button and hold. But no bell after min. 1 minute. Instrument is in the spot reading position. Calibration complete inst_handle_calibrate done 0x0 Ready to read strip pass A Press 'f' to move forward, 'b' to move back, 'n' for next unread, 'd' when done, Esc or 'q' to quit without saving. Trigger instrument switch or any other key to start:munki_imp_measure called Taking 14 measurments in Refl Scan mode called -- man-d