Normand,
You wrote:
"... a zone around the L axis with no patches"?
Did you use the -g parameter? With 128? As is -g128?
I have to get into the habit of throwing the -w and -W parameters on my targen
command line...
Thanks / Roger
-----Original Message-----
From: argyllcms-bounce@xxxxxxxxxxxxx <argyllcms-bounce@xxxxxxxxxxxxx> On Behalf
Of Normand Fortier
Sent: December 21, 2019 9:09 AM
To: argyllcms@xxxxxxxxxxxxx
Subject: [argyllcms] Re: Custom "non-Argyll" charts
I've tried this initially too, but the presence of many gray patches (I had
specified 128 I think) resulted in an zone around the L axis with no patches,
probably caused by the way patches are spread by targen. This has been observed
by others, although I can't find the links at the moment. Do observe the result
of targen (-w -W) to make sure you're not getting unwanted results. That is why
I decided instead to create a target with grey / near neutral patches, pick the
grey / near neutral patches from the resulting target and add them to the
general purpose target ti1.
Normand