On Feb 17, 2008 9:29 PM, Roger Breton <graxx@xxxxxxxxxxxx> wrote: > > I just tested this on XP and I read the entire chart successful. > > Maybe there is big variation between each chart. Maybe you also can > > try to replace the XYZ values in the ti2 file with the one you > > measured with measure tool, and read it again with chartread. > > In the ti2? I think it is too much work for me. I'll experiment with some > other i1_RGB_Scan charts who maybe better reproduced and with chartread > again. But, if I remember well, it did not work with the original i1_RGB > Scan chart supplied with my EyeOnePro. So, I am not too optimistic about > that. In the meantime, I have gone to ColorPort, import the i1_RGB_Scan > Reference file from MeasureTool and created a new version of that chart. I > just printed that chart on my Epson and I am about to try to read it in with > ColorPort and my EyeOnePro. If this works, then I'll have to find a way to > convert the data over to a CIE format for scanin... > > Roger Breton > Fixing the ti2 file will at least take care of the "There is at least one patch with a very unexpected response" messages. But I might be other problems. I have attached the file. Lars Tore Gustavsen