[argyllcms] Re: Chartread host initiated i1 strip reading
- From: Graeme Gill <graeme@xxxxxxxxxxxxx>
- To: argyllcms@xxxxxxxxxxxxx
- Date: Tue, 25 Jun 2019 23:16:43 +1000
Greg E wrote:
How does the monitor profile handle making it read? Also how does the iO
device cause it
to measure? There must be a software method, just not documented.
There is no documentation at all on the low level protocols - it all has to
be reverse engineered.
You can set it to execute N x D duration measurements. This works
fine when the measurement period is deterministic. I presume
this is how the i0 works, but I'm not 100% sure there isn't some
instruction that is only used with the i0, since I haven't looked
at i0 USB traces very much.
An normal strip read depends on the button to initiate and terminate.
Cheers,
Graeme Gill.
Other related posts: