[argyllcms] Re: ArgyllCMS V1.6.1 released.

  • From: "Xavi" <forsfors@xxxxxxx>
  • To: <argyllcms@xxxxxxxxxxxxx>
  • Date: Tue, 1 Oct 2013 18:20:35 +0200

Thank you for your clear explanation.

Regards,
Xavi.

-----Original Message-----
From: argyllcms-bounce@xxxxxxxxxxxxx [mailto:argyllcms-bounce@xxxxxxxxxxxxx]
On Behalf Of Graeme Gill
Sent: Tuesday, October 1, 2013 2:05 AM
To: argyllcms@xxxxxxxxxxxxx
Subject: [argyllcms] Re: ArgyllCMS V1.6.1 released.

Xavi wrote:

> " For instance if the black on your printer aren't super deep (say L* 
> of >
> 5) you may not notice the problem, since it's mainly due to some 
> electrical interference within the ColorMunki between the LED driver 
> and the spectral sensor, and a sufficiently large level of light will
swamp the error."

That's true, but it can also affect color accuracy for highly saturated
colors too - if any part of spectrum should be at a low level, then this
problem will tend to elevate the reading, causing errors in the a* and
(particularly) b* values. But errors in highly saturated colors are harder
to see, so perhaps this is not so significant.

Graeme Gill.



Other related posts: