This message was posted by signman on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/3/535.html Curious and curiouser...had the XT running on the slimline clamp, 5.5 x 6.5 for totebags with a design that was mainly a 'triangle' with filled white background, more detail over it. The background underlayment would start in the middle, sew out center to right, then go back and work from the far left back to center-leaving about 2 strips without stitching in the center. When the fill was sewn on, there was a visible 'stripe' down the center in the right light. Changed to the round hoops for sweatshirt, exact same design-didn't change anything. Watched the background underlayment-and it filled the entire area perfectly-starting in one corner and going all the way across. So there's a glitch in the sewout of Amaya 9 that senses a difference between hoop setups and changes your sewing sequence! Anyone else run into this? Roland =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================