[amayausers.com] Re: timing problems, i think. please help

  • From: theboards@xxxxxxxxxxxxxx
  • To: amayausers@xxxxxxxxxxxxx
  • Date: Thu, 3 Jun 2010 05:22:20 UT

This message was posted by Rod or Sharon on AmayaUsers.com. PLEASE DO NOT REPLY 
VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: 
http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/953/2.html#000027

TJ,

Please re-read my last post very carefully. I did not say "spin" the Z axis 
shaft, I said "rotate" it to machine headup.....notice I said "headup?"

Then and only then manually move the needlecase by hand to center a 
needlebar/needle with the presser foot and needleplate hole.

This training session is over... ;-))

Rod Springer
Amaya tech & Trainer
Embroidery Cottage, owner

=========================================================== 

The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list

===========================================================

Other related posts:

  1. Home
  2. amayausers
  3. Archive
  4. 06-2010