This message was posted by gcannon on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/1249.html#000002 When the machine went to change colors (needles) an error occurred either in a sensor or the software. If you have the design centered in the hoop you can just can reset the design then just go to the color in the design where you were using the move tool under tools>settings. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================