This message was posted by Etched In Thread on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/1321.html#000011 Hi there; just an update on the trimmer issue. Melco sent me a new trimmer module which I received this past Tuesday. Before installing, I checked the hooks at the back just to be sure they were still in place, which they were. Installed the new trimmer, oiled, and ran a test. It missed a couple of trims at the beginning, but from then on, it didn't miss a single trim. I'm about to run several large designs this weekend for a wedding dress so will have my answer as to whether this is the final answer to the problem. Comparing the new module to the old, the old knife was quite dull. How does that even happen on a machine that, at that point, had less than 100k stitches on it? No matter, I'm a happy camper, for now :-) =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================