This message was posted by Rod or Sharon on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/1/640.html#000009 Gini, The question John presented was not whether the auto acti-feed was on auto or standard but it was about the "Auto Lower Limit" setting that governs the lowest material setting parameter that you choose to allow the auto acti-feed to go to. This setting is found under "Settings", "Threadfeed". The default setting for this has been 1. If this setting is too high, false or real thread and/or bobbin breaks and poor quality embroidery will occur. Rod Springer Amaya Tech & Trainer =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================