This message was posted by Bill C @ Fineline on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/1/699.html#000007 Had this happen and found that the bill clamp arm got bent back and would not go past the sewing arm. Move the rack slowly turning the cap untill it is just above the sewing arm, if it will not clear, bend it forward untill it clears. check all thr cap hoops without a cap on it =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================