[amayausers.com] Re: X Motor Error using XT WACF

  • From: theboards@xxxxxxxxxxxxxx
  • To: amayausers@xxxxxxxxxxxxx
  • Date: Sun, 31 May 2009 03:58:33 UT

This message was posted by Rod or Sharon on AmayaUsers.com. PLEASE DO NOT REPLY 
VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: 

Something I have gotten into the  habit of....I always select the cap driver 
designation in the hoop selection and then senter it to the machine 
....before.... ever attaching the driver to the machine.

There had been a couple of time that I had a large hoop(44x30)  and it locked 
up the capdriver after selecting the correct cap driver and went to center the 
it to the machine.

Rod Springer
Amaya Tech & Trainer


The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list


Other related posts: