Will you share the name and contact information of your digitizer? Thanks, Donna Zbest472@xxxxxxxxxxxxx Zbest Embroidery,Inc -----Original Message----- From: amayausers-bounce@xxxxxxxxxxxxx [mailto:amayausers-bounce@xxxxxxxxxxxxx] On Behalf Of webmaster@xxxxxxxxxxxxxx Sent: Tuesday, February 26, 2008 8:11 AM To: amayausers@xxxxxxxxxxxxx Subject: [amayausers.com] Re: Which format for editing? This message was posted by GF on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/2/445.html#000002 I always get my designs in EXP format because hardly any digitizer uses the OFM format which is Melco specific. My digitizer is a Melco tech and he sends to me in EXP. I think if you convert the design to wireframe, you will then be able to add/delete whatever you need to from the design. You should also be able to ask your digitizer to do the revision for you as well without any extra cost. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list =========================================================== =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================