This message was posted by Debbie Rinehart on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/1/142.html#000007 Juli, I know you and I both use Generations and ever since I have been using export II all my trims are recognized, but every now and then, I will see the thread only partially cut or not at all. Most time if stretches the thread until the needle breaks. I've had my Amaya for 2 years now and never had a tech out, so it could need adjusted. I have cleaned under the needle plate a couple times, so it's not dirty under there. Not sure how to change the blade, but that might take care of the issue. Debbie in Indiana =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================