No, I did not try that. I will do that and see if it makes a difference. LuAnn ----- Original Message ----- From: "Mike Garber" <agraphic2@xxxxxxxxxxxx> To: <amayausers@xxxxxxxxxxxxx> Sent: Wednesday, December 06, 2006 2:56 PM Subject: [amayausers] Re: Too many missed trims HELP! > LuAnne, > > Did you try and remove the cover and clean the cutting area? > > Mike > > Image Embroidery wrote: > >>My little XT has decided to start giving me fits! >>Repeated missed trims. If I don't notice that the color did not trim, then >>I get the long thread stretched across the design that eventually breaks >>or causes other problems. >>I tried adjusting presser foot height, new needle, new location. The same >>design runs flawlessly on my NON-XT. >>Is there some kind of adjustment I can do? Or do I need a tech? >>Thanks, >>LuAnn @ Image Embroidery >>Because Your "Image" Matters >>=========================================================== >> >>The AmayaUsers Mailing List >>Website: http://www.amayausers.com >>Discussion Board: http://www.amayausers.com/boards >>Subscribe/Unsubscribe: http://www.amayausers.com/list >> >>=========================================================== >> >> >> >> > > > =========================================================== > > The AmayaUsers Mailing List > Website: http://www.amayausers.com > Discussion Board: http://www.amayausers.com/boards > Subscribe/Unsubscribe: http://www.amayausers.com/list > > =========================================================== =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================