This message was posted by Oregonian1a on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/1/614.html#000009 Update to my post above: I redid the embroidery using Design Shop Pro+ V7. I tried to load the file done in V9 from Amaya OS and it didn't recognize the format. I used the same fonts/sizes and the same column graphics that I did on the V9 cap. I left the 3 needles alone that had the problems with trimming (one broken). I left everything else alone. The design stitched out without a problem. This does not set me back. The only thing I can think of is there was either some setting somewhere that had been set by my trainers in V7 that I did not set right in V9, or there is an issue making V9 incompatable on my XT. As I thought about watching the V9 version sew out I remember thinking that there was many more loops of top thread pulling out the top. I didn't notice any while sewing the design with the V7 version. I also realized that I usually set actifeed to a min of 5 (for caps) and it was at the default which I think is 3. So before sewing I made sure that OS V7 was also set at 3. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================