[amayausers.com] Re: Thread Sensor Assembly - One Works Well, One Not So Well
- From: webmaster@xxxxxxxxxxxxxx
- To: amayausers@xxxxxxxxxxxxx
- Date: Sat, 17 May 2008 00:58:45 UT
This message was posted by levelbest on AmayaUsers.com. PLEASE DO NOT REPLY VIA
EMAIL. Instead, respond to the thread on the WEBSITE by clicking here:
http://www.amayausers.com/boards/ultimatebb.php?/topic/1/406.html#000004
Hugo posted this directly to the list, so I am going to post it here on the web
side of things so everyone can see...
"John,
You can also check the gap in your feeder gears as well as the gap on the take
up lever gears.
Another thing that comes to mind is the x cable tension, X-carriage bearing
load, y rail belt tension and y motor belt tension.
You can always swap the sensors on the machine and see whether they react
differently
Do all this while you are hopping and skipping and running in place!
Hugo"
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
Other related posts:
