This message was posted by Greenwing on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/2/1598.html#000001 I had good results with one layer of Poly mesh and on layer of "Stiff" medium tear away. you can also raise the min. thread feed to 3 or 4 if you still have issues. the design type can have a lot to do with it also. is their a lot of satins if so use a fill underlay with an edge walk with a 4pt margin. =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================