Hello, Ballyhoo has just posted in the Suppliers forum of AmayaUsers Discussion Boards under the title of New Robison Anton Thread. This thread is located at http://www.amayausers.com/discussion/showthread.php?5541-New-Robison-Anton-Thread Here is the message that has just been posted: *************** I have been using Robison Anton thread fairly exclusively for several years and have been very satisfied. The last time I ordered the supplier did not have any king spools of the colors I needed so I got the mini spools (1000 yds). When I went to load them onto my machines, they did not fit over the metal thread feed tubes. I have lots of R/A king and mini spools and have not had this problem. I needed to get the job out, so I took a drill and a large bit and drilled out the hole on the cone and it is OK. R/A said that they have not changed their specifications. Has anyone else had this problem? David Sklar Ballyhoo! Annandale VA *************** =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================