Hello,
Wishes has just posted in the Machines & Hardware forum of AmayaUsers
Discussion Boards under the title of Sewing with Matalic thread.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?6179-Sewing-with-Matalic-thread
Here is the message that has just been posted:
***************
Where is the pressure foot. If too low the thread snap. If the foot is too high
the thread the thread will shred.
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
