Hello,
Mama Kass has just posted in the Machines & Hardware forum of AmayaUsers
Discussion Boards under the title of trimming troubles.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?6167-trimming-troubles
Here is the message that has just been posted:
***************
Have you watched this happen? It sounds as though the thread may not actually
have been cut; when the machine moves to the next area, the thread pulls very
tight then snaps. This often happens with the metallic thread we use.
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================