Hello,
imported_ladydstitches200 has just posted in the Machines & Hardware forum of
AmayaUsers Discussion Boards under the title of Maintenance Procedures - X
Drive Carriage Rails.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?6056-Maintenance-Procedures-X-Drive-Carriage-Rails
Here is the message that has just been posted:
***************
Is there any way to tell if the x motor is bad ? My problem started with it
sewing in one place and not advancing stitches then i reset and tried to
trace but it made very loud sounds and stopped . Called melco all signs point
to x motor but sure would like to make sure ..to have on hand for tec any
thoughts 2006 xt ...thanks in advance norma
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
