Hello,
Rod or Sharon has just posted in the Machines & Hardware forum of AmayaUsers
Discussion Boards under the title of Thread Grabber/Cutter -.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?6062-Thread-Grabber-Cutter
Here is the message that has just been posted:
***************
The "grabber blade" does not cut the thread. It merely pushes the cut thread
back into the grabber trap. The thread is cut by a knife that swipes underneath
the needle plate.
When was the last time you cleaned and lubricated this selector/cutter
assembly? It may be that it is all jammed up with lint or some other debris.
It may be that the pushrod is off and not pushing and pulling the lower knife
back and forth. It may be that the stepper motor that drives this system has
gone kaput....
It may be that a tech will be needed...
Rod Springer
Amaya tech & Trainer
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
