Hello,
Rod or Sharon has just posted in the Machines & Hardware forum of AmayaUsers
Discussion Boards under the title of skipping stitches on only one needle.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?6061-skipping-stitches-on-only-one-needle
Here is the message that has just been posted:
***************
Mama Kass,
If this appears to only be specific to one needle ( #7 ) then the firs thing I
would check very closely would be the Pinch roller and the inner thread feed
roller. I say this because I know you primarily use "metallic" thread with what
you do. This can wear grooves in the rollers faster than regular thread.
Check to see if a groove on either the pinch or inner threadfeed roller is
present. This would mean that the thread is not being pinched tightly enough
and it could be slipping.
Also, what is you closest and furtherest needle designation for your hook
timing. When was hook timing last checked?
Rod Springer
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
