Hello,
John has just posted in the Machines & Hardware forum of AmayaUsers Discussion
Boards under the title of column widths on caps.
This thread is located at
http://www.amayausers.com/discussion/showthread.php/6687-column-widths-on-caps
Here is the message that has just been posted:
***************
---Quote (Originally by Theobear)---
I have two Amayas 2005 and 2008. Both are XTs (or at least the 2005 has the
round bobbin arm) . Sewing caps on them, same design, but on the 2008, the
lettering columns widths are much thinner and look crappy compared to the 2005.
Checked x-cable tension with the gauge plate and it is in spec (i did replace
this cable earlier this year though).
My question is, what else could be the culprit? I do notice the cap driver
moves more smoothly left to right on the 2005 (when not attached to the
carriage). This is the older one piece cap driver, where as the 2008 is the two
piece driver assembly. I also sew at 1100 spm on caps (usually 1200 spm on
flats).
---End Quote---
Try doing caps at 850/900. That's where we run ours.
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================
