Hello,
sewsew has just posted in the Machines & Hardware forum of AmayaUsers
Discussion Boards under the title of Needle case not moving correctly after
maintenance.
This thread is located at
http://www.amayausers.com/discussion/showthread.php/6617-Needle-case-not-moving-correctly-after-maintenance
Here is the message that has just been posted:
***************
---Quote (Originally by Rod or Sharon)---
Were you very careful when putting the black cover back on and tighten the
screws just enough that they are still slightly loose but the screws are in
deep enough so they are flush with the plastic? After that, you move the
needlecase so it can line it up so the needlebar studs can slide across evenly
without getting hung up. THEN FINISH TIGHTENING THE SCREWS. If not, you risk
the studs getting caught up and it could jam the needlecase or cut through the
plastic and the cover will need replaced.
Sharon Springer (I hope this was understandable!)
---End Quote---
Sharon,
Not really sure I understand. Just to see what was binding I took the cover
off and it is still binding. Is that my problem, that the cover is still off?
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================