Hello,
dsquitieri1 has just posted in the Machines & Hardware forum of AmayaUsers
Discussion Boards under the title of Amaya big red issues.
This thread is located at
http://www.amayausers.com/discussion/showthread.php?6545-Amaya-big-red-issues
Here is the message that has just been posted:
***************
Ibdo have an extensive amount of guages as far as training i have a very
mechanical background and have dealt with older embroidery machines
extensively, the reason for the pack changes were to replace broken ones the
people i purchased the machines looked as if they broke several needle packs as
well as the optical sensors, had called melco tech and at some point may
require his asistance but for now im trying to figure out everytging needed so
i can have a minimal bill from tech , seeeung as how it may wind up costing
less for a new machine that is why i asked if there is a way to test x motor i
have electrical guages but just arent sure what ohms are needed to run properly
or to tell if motor is shot
Sent from my SM-N920V using Tapatalk
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================