Hello,
Marcus has just posted in the Embroidery / How Do I? forum of AmayaUsers
Discussion Boards under the title of Gradient patterns.
This thread is located at
http://www.amayausers.com/discussion/showthread.php/6678-Gradient-patterns
Here is the message that has just been posted:
***************
Hello I am fairly new to the digitising world but I have been doing it for
about 3 months now and steadily learning tips and tricks. I have seen some
deigns which have a gradient fill. For example at one end a solid red which
ends up being a yellow at the other. I have design shop pro 9, and I don't
think there is a tick box to have the software do it for you, unless I have
missed it.
I have had a try with a pair of sunglasses which had black in one corner which
faded up to a silver to give a reflective look. I did it by splitting the
lense into four sections each with a diffierent thread density. Where the area
need to be black I sewed out at about .38 and at the other end it was above 1
but with the opposite values for the silver thread so this showed through. The
initial sew out was not too bad, but not quite a smooth transition. Just
wondered how others did it?
***************
===========================================================
The AmayaUsers Mailing List
Website: http://www.amayausers.com
Discussion Board: http://www.amayausers.com/boards
Subscribe/Unsubscribe: http://www.amayausers.com/list
===========================================================