This message was posted by TinaK on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/1/551.html#000003 Ed: I have a big red with all the upgrades of the XT for the hats. No where near the bill of the cap unfortunately. I had this problem the other day as well and took my Wacf off and did a needle down and it actually hit the plate so made the adjustment and it went fine. Now I checked it again today and needle is dead on still but still does the needle breaks. Last year when I had all the trouble with my machine right after I got it, it actually bent the pressure foot and Melco sent a new one but it never got replaced do you think that maybe that could be it and how hard is it to replace it? Also, why would it run fine on flats and just act up on the hats... Quitting early today so I can get a few hours of hunting in before sunset so will check after the sun goes down... =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================