As far as transporting it goes......I've taken mine to trade shows in the back of my SUV. I'd just recommend that you are obviously very careful moving it.....making sure not to allow the needlecase to bump or touch anything. Only grab/carry it by the "handles" that are cast into the metal base of the unit. You might need to take the thread off and lower the thread tubes to get it in a SUV....if it's a van with a side cargo door, you're probably ok. Brad -----Original Message----- From: amayausers-bounce@xxxxxxxxxxxxx [mailto:amayausers-bounce@xxxxxxxxxxxxx] On Behalf Of dsklar@xxxxxxxxxxx Sent: Wednesday, April 04, 2007 9:51 AM To: amayausers@xxxxxxxxxxxxx Subject: [amayausers] Moving Amaya to an Event I was asked to take one of my Amayas to an event to embroider shirts on site. Does anyone do this? Are there any issues in doing this that I need to be aware of? They want to pay a fixed for 4 hours of embroidering. They provide the shirts. Any thoughts on what to charge? Thanks. David Sklar Ballyhoo! Arlington, VA =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list =========================================================== =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================