This message was posted by Wishes on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/2/740.html Dear List, I have a design that is a six inch circle that is all fill. It is a seal for a tribe. There are a lot of jump stitches in this design leaving lots of criss crossing. I eleminated many of these jump stitches but when it went to sew out it came up with an X axis error. I realize they are to move the design to another space but how would I eliminate these without causing the error? Thanks Margaret =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================