This message was posted by Rod or Sharon on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/cgi-bin/ultimatebb.cgi?/topic/1/1003.html#000005 Deending on which side of the design has the 1/4" overlap, that is about the max I would push it in the hoop limits. Not learning how to utilize all the tools available to you just limits how flexible you can be to get the job done. It's all about time. There is not much risk if you just think about what you are doing.... Rod Springer Amaya Tech & Trainer =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================