This message was posted by Sewfly on AmayaUsers.com. PLEASE DO NOT REPLY VIA EMAIL. Instead, respond to the thread on the WEBSITE by clicking here: http://www.amayausers.com/boards/ultimatebb.php?/topic/1/95.html#000003 Make sure the column width is at least 1.2mm. If it is any narrower, the machine is basically going in and out of the same hole multiple times and the machine will read it as a thread break. Once I learned this at a digitizing seminar, I greatly reduced the number of thread breaks in my desigs. Hope this helps. Susan =========================================================== The AmayaUsers Mailing List Website: http://www.amayausers.com Discussion Board: http://www.amayausers.com/boards Subscribe/Unsubscribe: http://www.amayausers.com/list ===========================================================