Hugo, thanks for the quick response. Having a problem locating the optical sensor. Any further directions? Thanks again, Cindy @ Finyl Vinyl ----- Original Message ----- From: <HTorbidoni@xxxxxxx> To: <amayausers@xxxxxxxxxxxxxxxx> Sent: Monday, July 26, 2004 10:47 AM Subject: Re: [amayausers] Daily Power up > Cindy > > You have two optical sensors behind the needle case. > As you are looking at the needle case one is located behind the right side of > the case about half way up from the bottom. It's purpose is to see the flag > that protrudes from the black cover behind the needle case. If it doesn't see > the flag the machine will continue to move to the right until it finds it. > > Once you find the optical sensor, try blowing any lint or dust off of it. > Also check to see that the sensor is not rubbing on the flag which is part of > the black cover directly behind the needle case. The flag should be centered > inside of the sensor but not touching it. > > Go into your maintenance menu and the go to Steppers and select "Home"under > color change. > > The needle case should go to needle #9. > > If the needle case goes all the way over past #1 again you may have to put in > for a service call > > Hopes this helps. > > Hugo Torbidoni > H T Embroidery Repair > Harpers Ferry WV > > 304-724-8846 > --------------------------------------------------------------------- To unsubscribe, e-mail: amayausers-unsubscribe@xxxxxxxxxxxxxxxx For additional commands, e-mail: amayausers-help@xxxxxxxxxxxxxxxx